Sold out
Happymodel 0802 19000KV 1s Whoop spare motor
₹950.00 GST
1s Lipo battery 450mah 100C BT2
₹499.99 GST
1s Whoop replacement AIO – 5Amp with ELRS & VTX
₹6,825.00 GST
| Weight | .05 g |
|---|
Out of stock
Description
The Happymodel Diamond F4 AIO 5-IN-1 Flight Controller has a built-in VTX, ESC, OSD, and receiver – all on one triangle-shaped whoop board! The 3 corners fit 25.5mm whoop mounting spacing. This is the AIO board included on the ultra-light Happymodel Moblite6/7 whoops and is inspired by Happymodel’s Official Pilot – Angry Don FPV!
Features
- Diamond Mounting Pattern – 22.2×22.2×32.7mm
- Built-in 5A Blheli_S 4in1 ESC, Dshot600 ready
- Built-in Betaflight OSD (SPI Control)
- Built-in 25-200mW 5.8GHz VTX
- Built-in SPI ELRS Receiver
- Built-in 5V/1A BEC
Specifications
- DiamondF4 ELRS FC Firmware target: CrazybeeF4SX1280
- Power supply: 1S battery input (DC 2.9V-4.35V)
- MCU:STM32F411CEU6 (100MHZ, 512K FLASH)
- OSD: Built-in Betaflight (SPI Control)
- Sensor: MPU-6000 (SPI connection)
- BEC: Built-in 5V 1A
SPI ELRS V2.0 RECIEVER
- Packet Rate option: 50Hz/150Hz/250Hz/500Hz
- Compatibility: ExpressLRS V2.0 TX Module
- Antenna: Enameled copper wire antenna
- ExpressLRS Firmware version: V2.0
- Receiver protocol: SPI ExpressLRS
- Telemetry output Power: <12dBm
- RF Frequency: 2.4GHz
ONBOARD 4-IN-1 ESC
- Power supply: 1S LiPo/LiPo HVCurrent: 5A continuous peak 6A (3 seconds)
- Factory firmware: O_H_5_REV16_8.HEX
- Support BLHeliSuite programmable
- MCU upgraded to EFM8BB21
- Default protocol: DSHOT600
ONBOARD 5.8 GHZ VTX
- Transmitting Power: 0/RCE/25mw/100mw/400mw
- Current (5v): <650ma (400mw)
- Firmware version: OPENVTX
- Power supply: DC 5V
- RCE Mode support
- PIT Mode support
- Smart audio v2.1
- Channels:48ch
IMPORTANT NOTES
- SPI ELRS receiver. Cannot flash ExpressLRS firmware separately.
Includes
- 1x Happymodel Diamond F4 FR AIO 5-in-1 Flight Controller – SPI ELRS
- 2x Connecting Wire
- 4x Damping Balls
- 4x Screws
Related products
-50%
Sold out
Sold out
